Octoberfest USPSA Match @ Marysville 2014

Much better. I tanked one stage (the barrels & ipsc targets) but managed to squeeze in 2nd. I shot with the match winner Nick and it was clear I was way-way behind on almost all the stages. I’m proud that I didn’t let that get to my head though and I continued to shoot at my own pace.

Now if only I can remember to grip my gun tight. I keep forgetting to do so and my dot runs all over the place.

USPSA @ Paul Bunyan Rifle Club – “Tornado Alley”

I shot at my pace today getting my hits but not going at breakneck speeds. Came in 2nd behind TimR. Could have gone faster in some of the stages as it felt really slow, but I would probably be dropping lots of points. Will try to gradually speed up at the next match.

Sighting in my 9mm USPSA Open Racegun

Finally got to the range to sight-in the C-more sight that I replaced recently. You can see from the video that the new 9mm Major CFE Pistol rounds I loaded is much more consistent and accurate. Excited to finish off my HS-6 loads and start using the CFE rounds.

Assembling a 300 Blackout AR15 Pistol from Scratch

Here’s a really long video of me assembling a 300 Blackout AR-15 Pistol from scratch.

Here’s the full parts list:
– STI Upper+Lower
– KAK 8″ 300 BLK Barrel
– KAK Gen 2 Buffer Tube+buffer+spring
– KAK Grip+triggerguard+forward assist+dust cover+charging handle+muzzle device+gas system
– BCM Bolt Carrier Group
– DPMS LPK
– Magpul BAD Lever
– Magpul ASAP
– YHM Takedown Pins
– UTG Pro Superslim 9″ handguard
– SB15 Pistol Brace
– Primary Arms Red Dot + Fortis mount

Cleaning a 2011 Open Division Competition Pistol

Here’s the next video I promised that shows you how I clean my custom JPL Precision Open Gun that I use for USPSA. There are many ways to clean a gun, but this one is mine. 🙂

Swapping a C-more Serendipity Red Dot Sight

Ever since I had that crack in my C-more, I haven’t had the chance to replace it until recently. Here’s a quick video of me replacing my existing C-more sight with a brand new one.