Looks pretty much like the previous 013 holster they have except that it’s cut down and looking more modern. Can’t wait to see more details about this holster but I hope they have relieved the left side of the holster so I can install a thumbrest. The current 013 holster’s left shield is too high and gets in the way of it.
Here the 014 in Racing Red :
I broke my SDM Front Sight fiber rod when I dropped my gun at the recent Area 1 Championships. Ordered some replacement fiber rods from SDM and they came in today.
The green one looks much brighter, but I’m used to the red, so I went with it. Insert the rod all the way into the “crimped” portion of the SDM sight :
Trim it off with a sharp knife, make sure the cut is straight. A suggested way to cut it is with a sharp nail clipper.
Then use a lighter to melt the tip. The amount of fiber sticking out determines how large the melted portion will be.
After that, for good measure, I put a very small dab of Loctite at the end of the fiber and behind the melted portion to make sure the fiber stays on the sight.
There, back to normal. Sweet! I got my baby back.